Juniper JUNOSE 11.1.X - SYSTEM EVENT LOGGING REFERENCE GUIDE 3-24-2010 Reference Manual page 247

Attributes that are added to outbound RADIUS requests, including Access-Request,
Debug
Acct-Start, Acct-Stop, interim accounting requests, tunnel accounting requests, and
ICR partition accounting requests; IPv6 accounting VSA attributes
(IPv6-Acct-Input-Octets [26-151], IPv6-Acct-Output-Octets [26-152],
IPv6-Acct-Input-Packets [26-153], IPv6-Acct-Output-Packets [26-154],
IPv6-Acct-Input-Gigawords [26-155], and IPv6-Acct-Output-Gigawords [26-156]) that
are added to outbound RADIUS requests, including Acct-Stop and interim accounting
requests; IPv6 RADIUS IETF and VSA attributes (Ipv6-NdRa-Prefix [26-129],
Ipv6-Virtual-Router [26-45], Ipv6-Local-Interface [26-46], Ipv6-Primary-DNS [26-47],
Ipv6-Secondary-DNS [26-48], Framed-IPv6-Route [99], Framed-IPv6-Pool [100],
Delegated-Ipv6-Prefix [123]) that are added to Access-Accept (inbound RADIUS
requests), Acct-Start, Interim-Acct, and Acct-Stop messages; DHCP Option 82 [26–159]
which is added to trigger packet mirroring for DHCP subscribers
None
Filter
remOps
Remote operations
Description
None
Emergency
None
Alert
None
Critical
Internal error
Error
Maximum table size reached; ICMP failure; same target probed by more than one
Warning Log
entry
Remote operations application begin/start; ping, traceroute, or nslookup entry; create,
Notice Log
modify, or remove; unexpected packet receive; invalid target or source address; late
packet receive
None
Info
Ping, traceroute, or nslookup session begin or end; packet receive; duplicate receive
Debug
None
Filter
resourceThresholdTrap
Resource threshold trap log
Description
Chapter 17: R Commands
223
remOps