Table of Contents
Advertisement
Log messages are not synchronized between primary and redundant SRP modules.
During a switchover from a primary to a redundant SRP module, existing log messages
are not transferred to the redundant SRP module.
Logging Platform Considerations
System logs are supported on all E Series routers.
For information about the modules supported on E Series routers:
Configuring Event Logging
By default, event logging is enabled and has default settings. This section explains
how to change settings to customize event logging to fit your needs.
The next sections explain how to configure individual and systemwide logs, how to
format timestamps for log messages, and how to configure log filters.
See the ERX Module Guide for modules supported on ERX7xx models, ERX14xx
models, and the Juniper Networks ERX310 Broadband Services Router.
See the E120 and E320 Module Guide for modules supported on the Juniper
Networks E120 and E320 Broadband Services Routers.
Set a baseline for when the system begins logging messages.
host1#baseline log 11:12:55 April 30 2002
Set the log severity.
host1(config)#log severity warning
Remove the limit on the number of buffers available for an event category.
host1(config)#log unlimit qos
Set the log verbosity.
host1(config)#log verbosity low
Log messages to a specified destination.
host1(config)#log destination syslog 10.10.9.5 include ospfGeneral
mplsGeneral os
Select fields to be added to logs.
host1(config)#log fields timestamp instance no-calling-task
Enable logs destined for a console to be displayed at the current console device.
host1#log here
Chapter 1: System Logging Overview
Logging Platform Considerations
5
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE 11.1.X - SYSTEM EVENT LOGGING REFERENCE GUIDE 3-24-2010 and is the answer not in the manual?
Questions and answers