Juniper JUNOSE 11.1.X - SYSTEM EVENT LOGGING REFERENCE GUIDE 3-24-2010 Reference Manual page 35

using systemwide level commands until you return the event category to its
default, unassigned state by using the no log severity eventCategory command.
To return all logs, systemwide and individual, to their default, unassigned severity
level, use the no log severity * command.
To see whether individual or systemwide severity and verbosity settings are in
effect, use the show log configuration command.
The following example demonstrates the effects of event category state in regard to
Example
using systemwide commands:
In Configuration mode and having made no changes to the severity settings of
1.
any event categories, view the log configuration:
host1(config)#run show log config
log destination console severity WARNING
log destination nv-file severity CRITICAL
log destination syslog 10.10.4.240 facility 7 severity DEBUG
no log engineering
log fields timestamp instance no-calling-task
no log here
Warning: Logging to this terminal is disabled
no log severity
category
--------------------
aaaAtm1483Cfg
aaaEngineGeneral
aaaServerGeneral
aaaUserAccess
addressServerGeneral
ar1AaaServerGeneral
atm
atm1483
atmAal5
Notice that the atm event category has a default severity of Error.
Change all event categories to Warning, systemwide, and view the log
2.
configuration:
host1(config)#log severity warning
host1(config)#run show log config
log destination console severity WARNING
log destination nv-file severity CRITICAL
log destination syslog 10.10.4.240 facility 7 severity DEBUG
no log engineering
log fields timestamp instance no-calling-task
no log here
Warning: Logging to this terminal is disabled
log severity WARNING
category
--------------------
aaaAtm1483Cfg
aaaEngineGeneral
severity verbosity
-------- ---------
ERROR low
ERROR low
ERROR low
ERROR low
ERROR low
ERROR low
ERROR low
ERROR low
ERROR low
severity verbosity
-------- ---------
WARNING low
WARNING low
Configuring Log Severity for Individual and Systemwide Logs
Chapter 1: System Logging Overview
filters notes
------- -----
filters notes
------- -----
1
1
11