Table of Contents
Advertisement
JUNOSe 10.2.2 Release Notes
Monitoring the Status of Transfer of Updated DSL Line Rate Parameters to the
COPS Server
Purpose
Action
108
Monitoring the Status of Transfer of Updated DSL Line Rate Parameters to the COPS Server
Display whether the SRC client is enabled to retrieve updated DSL line rate details
from ANCP and send them to the SRC client with corresponding COPS messages.
The command output refers to the SRC client by its former name, SSC client.
To display the status of transfer of updated line rate parameter details from the SRC
client to the COPS server.
The line highlighted in bold is the field added for this feature in the output of this
command. The added line specifies whether line rate parameters are sent to the
COPS server with the other COPS messages.
host1#show sscc info
The SSC Client configured protocols : IP(v4), DHCP(v4), L2TP(LAC)
The SSC Client is currently unconnected
The SSC Client configured servers are:
Primary: 10.10.2.2:3
Secondary: 0.0.0.0:0
Tertiary: 0.0.0.0:0
Local Source: FastEthernet 0/0, Local Source Address: 10.13.5.61
The configured transport router is: default
The configured retry timer is (seconds): 90
The configured update-policy-request is: Enabled
The connection state is: NoConnection
SSC Client Statistics:
Policy Commands received
Policy Commands(List)
Policy Commands(Acct)
Bad Policy Cmds received
Error Policy Cmds received 0
Policy Reports sent
Connection Open requests
Connection Open completed
Connection Closed sent
Connection Closed remotely 0
Create Interfaces sent
Delete Interfaces sent
Active IP Interfaces
IP Interface Transitions
Synchronizes received
Synchronize Complete sent
Internal Errors
Communication Errors
Tokens Seen
Active Tokens
Token Transitions
Token Creates Sent
Token Deletes Sent
Active Addresses
Address Transitions
Create Addresses Sent
Delete Addresses Sent
Authentication Successes
Authentication Failures
0
0
0
0
0
0
0
0
0
0
2
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
Advertisement
Table of Contents
