Juniper JUNOSE 11.1.X - SYSTEM EVENT LOGGING REFERENCE GUIDE 3-24-2010 Reference Manual page 30

JUNOSe 11.1.x System Event Logging Reference Guide
baseline log
log destination
NOTE: You can display traffic logs such as ipTraffic, icmpTraffic, tcpTraffic, and
udpTraffic only through the show log data command or from the SRP module
console. You cannot redirect traffic logs elsewhere, such as to a system log or
nonvolatile storage file, or to a Telnet session.
6
Configuring Event Logging
Use to set a baseline for logging events. Only log messages timestamped after
the baseline appear when you enter the show log data delta command.
To use the current system time, do not enter any options.
To set a specific time, use the following syntax:
Hour:Minute[:Second] Current time in 24-hour format. Seconds are optional.
utc Enter this keyword to indicate that the time entered is in universal
coordinated time (UTC), rather than local time.
To set a specific date, use the following syntax:
Month Day Year You must spell out the name of the month.
last-reset Causes the system to display log messages generated since the last
time the system was reset
Examples
host1#baseline log 11:12:55 April 30 2002
host1#baseline log last-reset
There is no no version.
See baseline log.
Use to log messages to the specified destination, including system log, console,
and nv-file (nonvolatile storage).
Use the severity keyword to limit the messages logged based on priority level.
The following information applies to logging messages to system log servers.
You can have multiple system log servers, but must configure logging to
each one separately.
A particular message within a specified event category is logged to a particular
system log server only if the priority of the message is greater than or equal
to both the priority of the event category and the priority of that system log
server.
If you log messages to a system log server, you can also specify:
facility Specifies a facility ID on the system log destination host. The
range is 0–7, representing the logging facilities local0–local7.
include Logs only the listed categories to system log; no other
categories are logged unless specifically included by issuing this
command again.