Juniper JUNOSE 11.1.X - SYSTEM EVENT LOGGING REFERENCE GUIDE 3-24-2010 Reference Manual page 67

None
Debug
access-class This filter is not currently supported
Filter 1
peer See description of the bgpRoutes peer filter for information about this filter
Filter 2
route-map This filter is not currently supported
Filter 3
router See description of the bgpRoutes router filter for information about this filter
Filter 4
in Matches on traffic coming into the router
Filter 5
out Matches on traffic going out of the router
Filter 6
NOTE: Send messages are logged to the bgpKeepAlives log when a message is added
to the send queue. A debug message is logged in to the bgpConnections log when
the message is actually passed to TCP.
bgpMessages
BGP protocol messages
Description
None
Emergency
None
Alert
None
Critical
None
Error
Unknown message type received; invalid field in received message; notification
Warning Log
message received or sent; invalid capability length in received ORF capability; invalid
capability value in received ORF capability; invalid ORF in received ORF capability;
ORF entries exceeded maximum limit in received prefix list
Open message received or sent; update message received or sent; route-refresh
Notice Log
message received or sent; route-refresh-cisco message received or sent; received
ORF capability; received route refresh message with ORF entries
None
Info
Keepalive message received or sent (Full decode of message logged if verbosity is
Debug
high)
Chapter 4: B Commands
43
bgpMessages