Cisco CRS-1 - Carrier Routing System Router Getting Started Manual page 88

Bringing Up a Single-Chassis System for the First Time
DETAILED STEPS
Allow the system to fully boot. Information similar to the following output should appear on the console
Step 1
screen:
System page at phys:07ffe000 user:7fc06000 kern:87ffe000
Starting next program at v80065e80
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer Software
clause at DFARS sec. 252.227-7013.
Copyright (c) 2004 by cisco Systems, Inc.
Bandwidth Mode : Full Bandwidth
Press RETURN to get started.
This message and summary appears only during initial system startup.
Note
Type yes or press Return to enter the configuration dialog:
Step 2
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]: yes
Step 3 Type yes or press Return to enter the basic management setup:
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity for management of the system.
Would you like to enter basic management setup? [yes/no]: yes
Type the router name and press Return. This name appears at the router CLI prompt.
Step 4
Configuring global parameters:
Enter host name: router
Step 5 Type the username for the root-system login and press Return:
Enter root-system username: crs
Type the password for the root-system login and press Return:
Step 6
Enter root-system password: 04Secret
Cisco CRS-1 Series Carrier Routing System Getting Started Guide
4-6
Restricted Rights Legend
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Chapter 4 Bringing up a New Cisco CRS-1 Router