Cisco CRS-1 - Carrier Routing System Router Getting Started Manual page 94

Chapter 4 Bringing up a New Cisco CRS-1 Router
Bringing Up a Single-Chassis System for the First Time
For more information on the show platform command, refer to the "Hardware Redundancy and Node
Administration Commands on Cisco IOS XR Software" section in the Cisco IOS XR Interface and
Hardware Component Command Reference.
show redundancy Command
To display information about the primary (active) and standby (inactive) RPs, enter the show
redundancy command as follows:
RP/0/RP0/CPU0:router# show redundancy
This node (0/RP0/CPU0) is in ACTIVE role
Partner node (0/RP1/CPU0) is in STANDBY role
Standby node in 0/RP1/CPU0 is ready
Cisco CRS-1 Series Carrier Routing System Getting Started Guide
4-12