Logging In To The Router; Cli Prompt - Cisco CRS-1 - Carrier Routing System Router Getting Started Manual

Logging In to the Router

Logging In to the Router
To log in to the router, perform the following steps:
Establish contact with the router through a terminal console or a Telnet session. Ask you system
Step 1
administrator for the address and port number for the router or terminal server:
a.
b.
Enter your username and password:
Step 2
User Access Verification
Username: crs
Password: password
RP/0/RP0/CPU0:router#
Note

CLI Prompt

After you log in, you see the CLI prompt for the Cisco IOS XR software. This prompt identifies the
name of your router, and the CPU to which you are issuing commands. In most cases, this prompt
represents the "CPU0" in the primary RP that controls the system.
The CLI prompt represents the path, through the router, to the CPU that executes the commands you
enter. (See
prompt is described in
Table 2-1
Prompt Syntax Components
type
rack
slot
Cisco CRS-1 Series Carrier Routing System Getting Started Guide
2-4
If using a terminal directly connected to the Console port, enter:
telnet access-server-address port
If connecting remotely using a Telnet or Secure Shell (SSH) connection, enter:
telnet device-port-address
Passwords are case-sensitive.
Figure 2-3.) The syntax for the CLI prompt is: type/rack/slot/module: router-name#. The CLI
Table 2-1.
CLI Prompt Description
Chapter 2
Description
Type of interface or card that you are communicating with. For most
user communication tasks, the type is "RP."
Chassis number of the rack. In a single-chassis system, the rack is
always "0."
Physical slot where the primary RP is installed: "RP0" or "RP1."
Cisco IOS XR Basic Configuration Management