Exiting Rom Monitor Mode - Cisco CRS-1 - Carrier Routing System Router Getting Started Manual

Appendix A ROM Monitor Guide
Table A-6
Command
help or ?
-?
Note Commands are case sensitive. You can halt any command by pressing Ctrl-C.
Examples
The following example shows display that appears when you enter the ? command:
rommon B5 >
alias
show_bcm_links
show_bcm
boot
confreg
cont
context
dev
dir
dis
dnld
help
history
meminfo
dumpspd
dumpplaneeeprom
repeat
reset
scanpci0
scanpci1
set
smptest
sync
tftpdnld
unalias
unset
version
writei2c
rommon B2 >

Exiting ROM Monitor Mode

To exit ROMMON mode, you must change the configuration register to 0x2 and reset the router. This
process can be done either by entering CLI commands or by responding to prompts.
Help Commands in ROMMON
Description
Displays a summary of all available ROM monitor commands.
Displays information about command syntax.
?
set and display aliases command
Show Links status on Broadcom Switches
Show Broadcom Switches Information
boot up an external process
configuration register utility
continue executing a downloaded image
display the context of a loaded image
list the device table
list files in file system
disassemble instruction stream
serial download a program module
monitor builtin command help
monitor command history
main memory information
Dump the Serial Presents Detect info from the SDRAM DIMMs
Dump the contents of the back plane
repeat a monitor command
system reset
scan for devices on PCI bus 0
scan for devices on PCI bus 1
display the monitor variables
Test the other CPU on an SMP board
write monitor environment to NVRAM
tftpdnld no longer available, use boot
unset an alias
unset a monitor variable
display rommon software, board, version
Write to an I2C device
Cisco CRS-1 Series Carrier Routing System Getting Started Guide
Exiting ROM Monitor Mode
A-27