Cisco CRS-1 - Carrier Routing System Router Getting Started Manual page 107

Chapter 5 Initial Configuration of the Cisco IOS XR Software
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/RP0/CPU0:router# configure
Step 2 logging {ip-address | hostname}
Example:
RP/0/RP0/CPU0:router(config)# logging 10.1.1.1
Step 3 logging trap severity
Example:
RP/0/RP0/CPU0:router(config)# logging trap debugging
Step 4 logging console [severity]
Example:
RP/0/RP0/CPU0:router(config)# logging console
emergencies
Step 5 logging buffered [severity | buffer-size]
Example:
RP/0/RP0/CPU0:router(config)# logging buffered 1000000
Step 6
commit
Example:
RP/0/RP0/CPU0:router(config)# commit
Step 7
end
Example:
RP/0/RP0/CPU0:router(config)# end
Step 8
show logging
Example:
RP/0/RP0/CPU0:router# show logging
Configuring Logging and Logging Correlation
Purpose
Enters global configuration mode.
Specifies a syslog server host to use for system
logging.
Limits the logging of messages sent to syslog
servers to only those messages at the specified
level.
See Table 5-4
•
severity levels.
Logs messages on the console.
When a severity level is specified, only
•
messages at that severity level are logged on
the console.
See Table 5-4
•
severity levels.
Copies logging messages to an internal buffer.
Newer messages overwrite older messages
•
after the buffer is filled.
Specifying a severity level causes messages at
•
that level and numerically lower levels to be
logged in an internal buffer. See
a summary of the logging severity levels.
The buffer size is from 4096 to
•
4,294,967,295 bytes. Messages above the set
limit are logged to the console.
Commits the target configuration to the router
running configuration.
Ends the configuration session and returns to
EXEC mode.
Displays the messages that are logged in the
buffer.
Cisco CRS-1 Series Carrier Routing System Getting Started Guide
for a summary of the logging
for a summary of the logging
Table 5-4 for
5-13