Configuration Examples For Managing Packages; Copying And Adding A Package To The Router: Example - Cisco CRS-1 - Carrier Routing System Router Getting Started Manual

Configuration Examples for Managing Packages

Packages can be removed only if they are deactivated from all cards. A package cannot be deactivated if
that package is required by another active package. When a deactivation is attempted, the system runs
an automatic check to ensure that the package is not required by other active packages. The deactivation
is permitted only after all compatibility checks have passed.
To preview the impact of a deactivation, enter the test option with the install deactivate command to
Tip
display the results of the action without impacting the router.
Configuration Examples for Managing Packages
This section provides the following package management examples:
•
•
•

Copying and Adding a Package to the Router: Example

In the following example, the Multicast package is added to the system:
RP/0/RP0/CPU0:router# install add tftp://255.255.255.255/files/hfr-mcast-p.pie to disk0:
Install: The idle timeout on this line will be suspended for synchronous install
operations
Install: Starting install operation. Do not insert or remove cards until the operation
completes.
Install: Now operating in asynchronous mode. Do not attempt subsequent install operations
until this operation is complete. RP/0/RP0/CPU0:router#Install 1: Install operation 'add
/tftp://255.255.255.255/files/hfr-mcast-p.pie to disk0:' assigned request id: 1 Install 1:
Downloading PIE file from /tftp://255.255.255.255/files/hfr-mcast-p.pie
Install 1:
Install 1: Downloaded the package to the router
Install 1: Verifying the package
Install 1: Verification of the package successful [OK]
Install 1: Going ahead to install the package...
Install 1: [OK]
Install 1: Add of '/tftp://255.255.255.255/files/hfr-mcast-p.pie'
completed.
Install 1: Add successful.
Install 1: The following package(s) and/or SMU(s) are now available to be
activated:
Install 1:
Install 1: Please carefully follow the instructions in the release notes when activating
any software Install 1: Idle timeout on this line will now be resumed for synchronous
install operations
Cisco CRS-1 Series Carrier Routing System Getting Started Guide
6-30
Copying and Adding a Package to the Router: Example, page 6-30
Activating and Testing a Package on the Router: Example, page 6-31
Activating a Package on the Router: Example, page 6-33
Transferred 981322 Bytes
disk0:hfr-mcast-1.2.0
Chapter 6 Managing Cisco IOS XR Software Packages