Cisco CRS-1 - Carrier Routing System Router Getting Started Manual page 172

Configure Routing Interfaces
Restrictions
For this release, the following line cards are supported:
•
•
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Step 2
interface type instance
Example:
RP/0/RP0/CPU0:router(config)# interface pos
0/2/0/0
Cisco CRS-1 Series Carrier Routing System Getting Started Guide
7-16
Quad OC-192 packet-over-SONET/Dynamic Packet Transport PLIM (see
16 x OC-48 packet-over-SONET/Dynamic Packet Transport PLIM (see
configure
interface type instance
ipv4 address ipv4-address subnet-mask
Configure additional features on the interface.
no shutdown
commit
end
show interfaces
Chapter 7 RP Redundancy and Hardware Administration on Cisco IOS XR Software
Purpose
Enters global configuration mode.
Specifies the physical port and enters interface configuration
mode.
See the "Specifying the Interface "Instance"" section on
•
page 7-11 for more information.
Figure 7-5)
Figure 7-6 and Figure 7-7)