Cisco CRS-1 - Carrier Routing System Router Getting Started Manual page 147

Chapter 6 Managing Cisco IOS XR Software Packages
Adding Packages that are Resident on the Router
Once package files have been installed on the router, you can use the install add command to unpack
PIE files and copy the enclosed software to disk0: on the primary RP. This process does not impact router
operations. The following command syntax is used:
install add pie-file to device
Example:
RP/0/RP0/CPU0:router# install add disk1:/hfr-k9sec-p.pie-1.0.0 to disk0:
Multiple versions of a software package can be added to the storage device without impacting the
Note
running configuration, but only one version of a package can be activated for a card.
Copying and Adding Files in One Step from a Network Server
The commands listed in
of network file servers.
Table 6-8 Syntax for Copying and Adding Package Files to the Router
Server Type
TFTP
FTP
rcp
Table 6-8 show how to copy and add package files to the router from three types
Command and Example
The following command syntax is used:
install add tftp://hostname_or_ipaddress/directory-path/pie-name to target-device
Example:
RP/0/RP0/CPU0:router# install add tftp://10.1.1.1/images/hfr-k9sec-p.pie to
disk0:
The following command syntax is used:
install add ftp://username:password@hostname_or_ipaddress/directory-path/pie-name to
target-device
Example:
RP/0/RP0/CPU0:router# install add
ftp://john:secret@10.1.1.1/images/hfr-k9sec-p.pie to disk0:
The following command syntax is used:
install add rcp://username@hostname_or_ipaddress/directory-path/pie-name to
target-device
Example:
RP/0/RP0/CPU0:router# install add rcp://john@10.1.1.1/images/gsr-k9sec-p.pie to
disk0:
Cisco CRS-1 Series Carrier Routing System Getting Started Guide
Package Management Procedures
6-25