Examples Of Hardware Show Commands - Cisco CRS-1 - Carrier Routing System Router Getting Started Manual

Commands to Display Hardware Status
Table 7-1 Commands Used to Display Node and Hardware Status (continued)
Command
show redundancy
show version
show interface
and
show ip interface

Examples of Hardware Show Commands

The following show command examples are provided:
•
•
•
•
•
show diags Command
In the following example, the information for a single node is displayed with the show diags nodeID
command:
RP/0/RP0/CPU0:router# show diags 0/2/cpu0
RACK
MAIN:
PCA:
Board State : IOS-XR RUN
PLD:
MONLIB: QNXFFS Monlib Version 2.1
ROMMON: Version 1.15(20040120:002937)
Cisco CRS-1 Series Carrier Routing System Getting Started Guide
7-2
show diags Command, page 7-2
show platform Command, page 7-3
show environment Command, page 7-3
show redundancy Command, page 7-3
show version Command, page 7-4
0 SLOT 2 : MSC(16OC48-POS/DPT)
type 500060, 0000-000000-00 rev 00 dev 000000
HW version 0.0 S/N SAD0719013M
0073-007648-04 rev 07
Motherboard: 0x0024, Processor: 0xda12, Power: 0xf100
Chapter 7 RP Redundancy and Hardware Administration on Cisco IOS XR Software
Description
Displays the redundancy status of the Route Processors (RPs). This
command also displays the boot and switch-over history for the RPs.
Displays a variety of system information, including hardware and
software version, router uptime, boot settings (configuration register),
and active software.
Display interface information (see the
section on page 7-7 for more information).
[CRS-1 ROMMON]
"Configure Routing Interfaces"