Commands To Display Hardware Status; Show Platform Command - Cisco CRS-1 - Carrier Routing System Router Getting Started Manual

Chapter 7 RP Redundancy and Hardware Administration on Cisco IOS XR Software

show platform Command

The following is sample output from the show platform command for all nodes in a router:
RP/0/RP0/CPU0:router# show platform
Node
-----------------------------------------------------------------------------
0/0/SP
0/0/CPU0
0/2/SP
0/2/CPU0
0/RP0/CPU0
0/RP1/CPU0
0/SM0/SP
show environment Command
In the following example, the LED status of the nodes in the router is shown:
RP/0/RP0/CPU0:router# show environment leds
0/2/*: Module (host) LED status says: OK
0/2/*: Module (plimasic) LED status says: OK
0/SM0/*: Module (host) LED status says: OK
show redundancy Command
In the following example, the output shows the show redundancy command used to display redundancy
status for a redundant pair:
RP/0/RP0/CPU0:router# show redundancy
This node (0/RP0/CPU0) is in ACTIVE role
Partner node (0/RP1/CPU0) is in STANDBY role
Standby node in 0/RP1/CPU0 is ready
Reload and boot info
----------------------
RP reloaded Fri Apr
This node booted Fri Apr
Last switch-over Fri Apr
Standby node boot Fri Apr
Standby node last not ready Fri Apr
Standby node last ready Fri Apr
There have been 2 switch-overs since reload
Type PLIM
MSC(SP) N/A
MSC 16OC48-POS/DPT
MSC(SP) N/A
MSC 16OC48-POS/DPT
RP(Standby) N/A
RP(Active) N/A
FC/S(SP) N/A
9 03:44:28 2004: 16 hours, 51 minutes ago
9 06:19:05 2004: 14 hours, 16 minutes ago
9 06:53:18 2004: 13 hours, 42 minutes ago
9 06:54:25 2004: 13 hours, 41 minutes ago
9 20:35:23 2004: 0 minutes ago
9 20:35:23 2004: 0 minutes ago
Cisco CRS-1 Series Carrier Routing System Getting Started Guide

Commands to Display Hardware Status

State Config State
IOS-XR RUN PWR,NSHUT,MON
IOS-XR RUN PWR,NSHUT,MON
IOS-XR RUN PWR,NSHUT,MON
IOS-XR RUN PWR,NSHUT,MON
IOS-XR RUN PWR,NSHUT,MON
IOS-XR RUN PWR,NSHUT,MON
IOS-XR RUN PWR,NSHUT,MON
7-3