Reset; Lamp; Midi - PROEL PLBR256MH2 - REV 07-2006 Manual

Press [ENTER] to save and leave this menu. Press fader 6 button ESC to leave this
menu without having a copy. Press ESC to cancel this copy and have another try.
Everytime you finish a copy successfully, it will automatically leave this menu. Press the
COPY button to have a new copy. Repeat the same procedure stated in the above
paragraph for every copy required.

RESET

This function allows you to send the reset command to your fixtures. Press the RESET
button to access the reset menu, its LED will be lit and a new window will appear in the
screen.
Press the fixture 1-16 button for several seconds until the fixture starts resetting. The
time you keep pressing for depends on the fixture's performance. Please remember you
should have assigned the reset channel and its values of on/off before you can carry out
this function.

LAMP

This function allows you to switch on or off the fixture lamp by DMX command. Press the
LAMP button to access the Lamp menu and its LED will be lit.
All the lamps are set to ON by default when this console is turned on. Press the
FIXTURE 1-16 button for 5 seconds and the relative LED will tun off. To switch on the
fixture lamp, you'll have to press the fixture 1-16 button for 5 seconds again until its LED
is lit.
Please remember you should have assigned the lamp channel and its values of ON/OFF
first before you can carry out this function.

MIDI

To activate MIDI operation, you must first select a MIDI channel identical to that of the
MIDI keyboard or sequencer. The PLBR256MH2 will send and receive MIDI program
changes according to the following table:
NOTE FUNCTION
0-47 (00H-2FH) Show 01-48
48-95 (30H-5FH) Chase 01-48
96-115 (60H-73H) Scene 01-20
75