Edit Steps - PROEL PLBR256MH2 - REV 07-2006 Manual

First you will have to select fixture if no fixture has been selected for the show. Press the
fixture 1-16 to select the fixture, the LED above the fixture number will blink briefly and
the fixture's effects will appear in the screen.
You may select several fixtures at a time, however, only the last one, whose LED blinks,
is active for the show. Meanwhile, a group of several fixtures can be active for the show.
Several fixtures with the same effects can make up a group. Press and hold down the
fixture button, and in the meantime press the fixture 1-16 to select several similar fixture
to make a group following selecting the group number by pressing the fader 1-6 button.
The group number is indicated by the lit LED above the button, and the LED of the
fixtures in the group will blink simultaneously.
Take note of selecting the similar fixture for one group, or a prompt message will appear
indicatine you to have a try again.
The fixture's effects will appear in the screen once the fixture is selected. You can press
the fader 1-6 directly below tha effects in the screen or Pan/Tilt button to enable or
disabile these effects. The LEDs corresponding to these effect are lit when these effects
are enabled, whereas th LEDs are off when these effects are disabile.
Press OK to continue your setting if there is more thsn one page of effects. When you
have finished these settings, please press OK oe ESC to return to earlier menu.
IMPORTANT! This console complies with LTP (Latest Takes Priority) principle, as a
result, if a fixture is used by more than one show, the latest activated show will surely
become the first consideration.

1.2 Edit Steps:

Move fader 4 or press [▲] / [▼] buttons until the message LOAD FROM CARD appears
in the screen. Press OK to access this setting menu, the fixture you selected for the
show will be enacle and its effects will appear in the screen. Yhis menu allows you to
create or modify the steps which make up the show.
Move the fader 1-6 and use the joystick to control the adjustment of enable fixture. If this
adjustment is satisfactory, press and hold doen the STORE button, a message will
appear in the screen.
68