PROEL PLBR256MH2 - REV 07-2006 Manual page 49

1.1.3 Internal Patch
When the LCD screen shows the message CREATE NEW FIXTURE, press OK then
move the fader 5 or press the [▲] / [▼] buttons until INTERNAL PATCH appears in the
screen.
Press OK and a new window will warn you to not reuse a channel for two or more
effects. Press OK again, the effect strings previously created in menu 1.1.2 LCD Effect
Label will appear. This function allows you to give an assignment of fixture channels
according to fixture profile. Move respective faders 1-6 to select appropriate channel
number for function effects in the screen directly above these faders 1-6. Also you can
press the [◄] / [►] buttons to pass from effect to effect, then use [▲] / [▼] to select the
desired channel number for the underline effect. Press OK to go on with channel
assignment if there is more than mne page. Had you finisched all channels assignment,
press ESC to return to the earlier menu. The storage is automatic.
NOTE: If you need to control Pan and Tilt movements by joystick, it's not necessary to
assign the their channel in this section. You must to do it in the next section. If you need
to control Pan and Tilt movements only by faders, you must to assign their channels in
this section and not in the next one. If you assign the channel in both section, all the
procedure will be wrong. The unit's movements cannot to be controlled by faders and
joysticks at the same time.
49