Setup - PROEL PLBR256MH2 - REV 07-2006 Manual

Flash (1-12)
These 12 buttons are used to bring an individual channel to full intensity. They also are
used in combination with the Flash Page button, to select the scene or the step number
of the chases or shows. "Latch" can be enabled when the buttons are pressed down for
2 seconds.
Flash Page
In combination with the Flash buttons, this button is used to page through four pages 1-4
of 12 scenes, 12 steps of the chases or shows.
Channel Bank
This button is used to select the channels between two banks, the first 1-12 channels,
and the second 13-24 channels.
Dimmer Master Fader
This fader is used to control the overall intensities of the 24 channels.
Grand Master Fader
This fader is used to determine maximum output of all dimmer dafers.
Preset Faders (1-8)
These 8 faders are used to control the dimmer levelof the preset respectively.
Blackout
When pressed all levels will go to zero. The flashing LED above the button will indicate
this). Pressing again all levels will return.
Audio Button
This button is used to enable or disable audio synchronized control of the selected
scenes, chases, shows and the strobe programs.

SETUP

First make sure that the console is in Fixture Control Mode by observing the fixture LED
indicator and LCD Screen on upper-right. The fixture LED indicator will be lit and the
LCD Screen will show the message "Select Fixture". Press the Setup button to activate
Setup Mode. A yellow LED above the button will blink briefly and the overhead LCD
Screen will show the message "Configuration & Setup Menu" indicating you're in Setup
menu.
The Setup menu contains 11 submenus: INTERNAL LIBRARY, PATCH, MIDI
CHANNEL, STROBE TYPE, GOOSENECK DIMMER, VIEW FREE MEMORY, SEND
DATA FILE, LOAD DATA FILE, UPDATE SOFTWARE, SAVE TO CARD AND LOAD
FROM CARD.
46