PROEL PLBR256MH2 - REV 07-2006 Manual page 50

1.1.4 Pan / Tilt Patch
When the LCD screen shows the message CREATE NEW FIXTURE press OH, then
movete fader 5 or press [▲] / [▼] PAN / TILT PATCH appears in the screen.
Pressing OK a warning message will appears in the screen telling you that every Pan
and Tilt channel should be solely reserved. Press OK again and a new window will
appear requesting you to assign the Pan or Tilt movemet of the fixture. Most fixtures
allow both 8 and 16 bit control, some only 8 bit. In 16 bit mode the Pan movement
requires two channels - high (H) and low (L) – so at the same way for the Tilt movement.
In 8 bit mode just one channel is used for Pan or Tilt, so only high position is set. Move
the respective faders 1-4 to select proper channel numbers for Pan coarse, Pan fineM
Tilt coarse an item, then use [▲] / [▼] to select the channel number for the item.
Once you finished all channels assignment, press OK or ESC to return to earlier menu.
The storage is automatic.
Caution! Please take note you must assign the Pan or Tilt movement of the fixture
correctly, otherwise you will not successfully create a new fixture.
50