Utility Facilties; Times; Copy - PROEL PLBR256MH2 - REV 07-2006 Manual

group code will appear in the screen. Press the faders 1-6 button below the group code
display to select a group, the LED will be lit to indicate the group code. Press the fixture
1-16 buttons to select the fixtures. Their LEDs will blink simultaneously. If the fixtures use
the same channel effects, these effects string will appear in the screen indicating this
group has been established successfully. If you want to try to group different fixtures, a
message "different ficture: no effect control" will appear in the screen. Once you've
created the groups of fixtures you can call the group by pressing the FADERS 1-6
buttons while holding the FIXTURE button.

UTILITY FACILTIES

TIMES

The [TIMES] button is used to set a multiplyning factor for the playing speed of the
shows, chases or scenes. When the Fixture LED is lit and the message "SELECT
FIXTURE" appears in the screen, press the TIMES button to access the times menu, its
LED will blink briefly and a new window will appear.
this function allows you to multiply speed within 25% - 400% for the shoes, chases or
scenes.
Press the SHOW button, the chows being played will appear in the screen. Press the
Fader 1-4 button or [◄] / [►] buttons to select the show which is indicated by the
marking "* *". Move the fader 5 ore press [▲] / [▼] to set the SPEED% within 25%-
400%. After all, the ultimate playing speed complies with the limit of 1 minute and 39.9
seconds. Proceed in this way to continue the setup of speed% for chases or scenes.
Additionally, the Flash 1-12 buttons can be used together with the FLASH PAGE button
to directly call a certain step of the active show or chase with the mark "* *".
Press the TIMES button again to leave this menu, its LED will turn off.

COPY

When the Fixture LED is lit and the message "SELECT FIXTURE" appears in the screen,
press the COPY button to access the copy menu, its LED will blink briefly and a new
window will appear.
this function allows you to make a copy between two shows, chases or scenes. Press
the SHOW button, move the fader 3 to select the source show you wish to have a copy,
then move fader 4 to select the target show wish to place this copy. After your selections,
press "OK", a prompt message will appear telling you the target show will be updated.ì
74