Record Chases - PROEL PLBR256MH2 - REV 07-2006 Manual

Dmx operator

Table of Contents

Available languages

2. RECORD CHASES

This console allows you to record up to 48 scenes of convetional light. Press the Record

buitton to cause itl LED to blink briefly, a new window wil appear telling you to select the

show, chase or scene you wish to record.

Press the Scene button to access edit scene menu, its LED will be lit, and a new window

will appear indicating you to select the scene you wish to edit.

Select the scene number using Flash buttons 1-12 together with the Flash page button to

access the pages 13-24, 25-36, 37-48.

This menu allows you to determine how many steps constituite this case, set the

duration time (i.e. chase rate) and crossfade for the chase, and create or modify the

steps which make up the chase.

Move fader 2 to select the value within 1-48 for the amount of step, then move the fader

5 to select the duration time (TIME) within 0 sec to 1 min and 39.9 sec. and move the

fader 4 to select the crossfade (CROSS%) i.e. percentage of the duration time,

within 0-100%.

Now we can start editing the step for the chase. The chse has a minimum of 48 steps

and each step consists create or modify a scene consisting of up 24 channels Use the

channel faders 1-12 together with the CHANNEL BANK button to create a desired

lighting setup (scene). Then Press the STORE button to save the scene as the 1

step of

the chase. The dsplay shows "step 2" indicating you are ready to edit the 2

step. Carry

on the 2

step and the rest steps until all steps are completed.

You can also directly access and call a step required to be edited. Press and hold the

STEP button, mean while press the Flash 1-12 together with the Page to select the step

that will be indicated by display. Proceed in the way stated in the above paragraph to edit

and save the step.

Press OK to save the attributes – the amount of the steps, standing time, crossfade etc.

and return to earlier menu. Press ESC to leave this menu without changing these

attributes.

Press RECORD or CHASE button causing Chase LED to go out, you will leave the

record chase menu.

Table of Contents

Table of Contents