PROEL PLBR256MH2 - REV 07-2006 Manual page 52

1.1.7 Reset / Lamp value
When the LCD screen shows the message CREATE NEW FIXTURE, press OK then
move the fader 5 or press [▲] / [▼], until RESET / LAMP VALUE appears in the screen.
Press OK and a message will appear in the screen warning you that Reset and Lamp
channels shold not be identical to the Pan, Tilt and Dimmer channels. Press OK again
and a new window will appear requesting you to assign the Reset and Lamp and their
on/off values. This function allows you to carry out Remote Reset and Remote Lamp
on/off if your fixture supports. Respectively move faders 1-6 to set up Reset and Lamp
as well as their on/off values. Also you can press [◄] / [►] to activate an item, then use
[▲] / [▼] to select the settings.
Once you have finished your settings, press OK to confirm it and return to the earlier
menu. If you want to give up just press ESC to return to the earlier menu.
Caution! Please take note you must correctly set up Reset and Lamp functions,
otherwise you will not successfully create a new fixture.
1.1.8 Dip-Switch Configuration
When the LCD screen shows the message CREATE NEW FIXTURE, press OK then
move the fader 5 or press [▲] / [▼], until DIP-SWITCH CONFIG. appears in the screen.
Press OK. A new windows indicate you to make a configuration fo dip-switch if
necessary. This function allows you to select the dip-switch and addressing system that
is used by your fixture. If your fixtures have new addressing setup instead of dip-switch
setup, you can ignore this setup. Move fader 2 to select the number of dip-switches
within 5-10, move fader 5 to select the addressing system between 0 (all the dip-
switches off = value 1) and 1 (dip-switch 1 = on ; rest = off).
Once you have finished your settings, press OK to confirm it and return to the earlier
menu. If you want to give up just press ESC to return to the earlier menu.
52