Activating Gss Devices From The Primary Gssm - Cisco GSS-4492R-K9 Administration Manual

Administration guide

page of 230

/ 230
Contents
Table of Contents
Bookmarks

Table of Contents

Replacing GSS Devices in Your GSS Network

You can now use the replacement primary GSSM in your GSS network.

Cisco Global Site Selector Administration Guide

2-34

Reconfigure the global server load-balancing configuration settings on

the new primary GSSM as described in the Cisco Global Site Selector

Global Server Load-Balancing Configuration Guide (GUI-based or

CLI-based version).

Send DNS queries to the new primary GSSM and ensure that it replies

properly to the queries. If the new primary GSSM replies properly,

proceed to step 13c. If it fails to reply properly, verify the network

connectivity settings and resend DNS queries to the device.

At the CLI of the standby GSSM and of each GSS device in your

network, enter the gss disable command to remove the existing

configuration, including the deletion of the GSSM database from the

standby GSSM, and return the GSS device to an initial state. The deletion

process includes removing all previously configured DNS rules and

keepalives.

gssm2.example.com# gss disable

At the CLI of the standby GSSM, enter the gss enable gssm-standby

command to configure the GSS device as the standby GSSM in the GSS

network and direct it to the primary GSSM. See the

Standby GSSM in the Network"

gssm-standby command.

gssm2.example.com# gss enable gssm-standby gssm1.example.com

At the CLI of each GSS, enter the gss enable command to enable your

GSS device as a GSS and direct it to the primary GSSM. Specify either

the domain name or the network address of the primary GSSM. See the

"Replacing a GSS in the Network"

enable command.

You may want to perform this step on one GSS device at a time to

Note

minimize disruptions on your GSS network.

gss3.example.com# gss enable gss gssm1.example.com

GSSM. See the