Specifying Recipients For Snmp Notification Operations - Cisco GSS-4492R-K9 Administration Manual

Chapter 6 Configuring SNMP
Specifying Recipients for SNMP Notification
Operations
Note
OL-10410-01
You can specify the recipient of an SNMP notification operation by using the
snmp-server host command in global configuration mode. To remove the
specified host, use the no form of this command.
To specify the recipient of an SNMP notification operation, perform the following
steps:
Log in to the CLI and enable privileged EXEC mode.
1.
gss1.example.com> enable
gss1.example.com#
Access global configuration mode.
2.
gss1.example.com# config
gss1.example.com(config)#
Enable the SNMP agent by entering the following command:
3.
gss1.example.com(config)# snmp enable
Specify the recipients of SNMP notification operations by using the
4.
snmp-server host command and a host-address and a community-string.
gss1.example.com(config)# snmp-server host 10.1.1.1 MyCommunity
Send SNMP traps to the specified host by entering the following command:
5.
gss1.example.com(config)#snmp-server host 10.1.1.1 MyCommunity
traps
You can configure a maximum of 10 hosts for traps notification.
Specify the version of the SNMP protocol used to send the traps by entering
6.
the version command and one of the available keywords:
1—Specifies SNMPv1 (the default).
•
2—Specifies SNMPv2c.
•
gss1.example.com(config)# snmp-server host 10.1.1.1 MyCommunity
traps version 2

Specifying Recipients for SNMP Notification Operations

Cisco Global Site Selector Administration Guide
6-7