Cisco GSS-4492R-K9 Administration Manual page 42

Understanding GSS Software Licenses
4.
5.
6.
Cisco Global Site Selector Administration Guide
2-8
Oct25 Node Manager
Oct25 Proximity
Oct25 Sticky
Oct25 Web Server (apache)
Oct25 drp
If necessary, enable the GSS software. For example, to configure the selected
device to act as the primary GSSM for your GSS network, enter the following
command:
gssm1.example.com# gss enable gssm-primary
See the Cisco Global Site Selector Getting Started Guide for details.
Enable the CNR server agent by using the cnr enable command in global
configuration mode as shown in the following example:
gssm1.example.com# config
gssm1.example.com (config)# cnr enable
# Starting Network Registrar Local Server Agent
If you did not properly install CNR on the GSS, the cnr enable command
displays a message informing you to first install the CNR license.
gssm1.example.com (config)# cnr enable
CNR enable failed. Please install CNR first
Verify that the CNR license installed properly:
gssm1.example.com# show license gss-all
Own (Primary GSS) info:
Pak number is:
DDOS Not Installed, Not Active
CNS Installed, Active
Verify that the CNR software is running on the primary GSSM:
gssm1.example.com# gss status
Cisco GSS - 2.0(2) GSSM - primary [Thu Nov
Normal Operation [runmode = 5]
START SERVER
14:28 Boomerang
14:30 CNR DNS Server
14:30 CNR Server Agent
14:28 Config Agent (crdirector)
14:28 Config Server (crm)
Chapter 2 Managing the GSS from the CLI
8 14:31:28 EDT 2007]
OL-10410-01