Stopping The Gss Software; Shutting Down The Gss Software - Cisco GSS-4492R-K9 Administration Manual

Chapter 2 Managing the GSS from the CLI

Stopping the GSS Software

Shutting Down the GSS Software

OL-10410-01
You must stop the GSS software before you perform the following tasks:
Upgrade GSS software
•
Perform a warm reboot
•
Restore GSS factory defaults
•
Disable an active GSS device
•
Perform GSS maintenance or troubleshooting
•
Use the gss stop command to stop the GSS software. For example, enter:
gssm1.example.com# gss stop
The following message appears when you stop the GSS software from the CLI.
Server is Shutting Down
Use the gss start command to restart the GSS software on the selected device after
it has been stopped. For example, enter:
gssm1.example.com# gss start
If you intend to power down a GSS device, we recommend that you use the
shutdown command to first shut down the GSS software. You should also shut
down the GSS software before you disable a GSS (see the
Software" section).
To shut down the GSS software, enter:
gssm1.example.com# shutdown
Cisco Global Site Selector Administration Guide
Stopping the GSS Software
"Disabling the GSS
2-27