Cisco GSS-4492R-K9 Administration Manual page 41

Chapter 2 Managing the GSS from the CLI
Note
3.
OL-10410-01
ftp> hash
Hash mark printing on (1024 bytes/hash mark).
ftp> get cnr_6_2_3-linux.gtar.gz
local: cnr_6_2_3-linux.gtar.gz remote: cnr_6_2_3-linux.gtar.gz
227 Entering passive mode ...
125 Using existing data connection
##################.....
226 Closing data connection; File transfer successful.
31625689 bytes received in 0.0013 secs (2.4e+02 Kbytes/sec)
ftp> quit
221 Service closing control connection
gssm1.example.com#
c. Install the CNR software on the GSS by using the cnr install command
and specifying the CNR license key as shown in the following example:
gssm1.example.com# cnr install cnr_6_3-linux.gtar.gz
cnr-license xxxx-xxxx-xxxx-xxxx
Installing CNR from cli-install. This may take a few minutes.
If you provide an invalid or expired license key, an error message appears
and the installation halts. The installation will then remove the CNR
installation directory, which may result in the removal of any previous
versions or installations of CNR.
The CNR installation does not activate the CNR server agent. You must
explictly enable CNR to start processing requests. See Step
Verify that the GSS software is running:
gssm1.example.com# gss status
Cisco GSS - 2.0(2) GSSM - primary [Thu Nov
Normal Operation [runmode = 5]
START SERVER
Oct25 Boomerang
? CNR DNS Server
? CNR Server Agent
Oct25 Config Agent (crdirector)
Oct25 Config Server (crm)
Oct25 DNS Server
Oct25 Database
Oct25 GUI Server (tomcat)
Oct25 Keepalive Engine
Understanding GSS Software Licenses
[ Server is not ready ]
[ Server is not ready ]
Cisco Global Site Selector Administration Guide
4.
8 14:27:33 EDT 2007]
2-7