Cisco GSS-4492R-K9 Administration Manual page 67

Chapter 2 Managing the GSS from the CLI
10.
11.
Note
12.
•
•
13.
OL-10410-01
Save your configuration changes to memory by entering the following
command:
gssm1.example.com# copy running-config startup-config
Configure the GSS device as the replacement primary GSSM in the GSS
network by entering the following command:
gssm1.example.com# gss enable gssm-primary
After entering the gssm primary-to-standby command, you should
ensure that at least 1 minute passes before you enter the gssm
standby-to-primary command in order to allow time for proper GSS
device synchronization.
Configuration changes do not take effect immediately. It may take up to 10
minutes before the other GSS devices in the network learn about the new
primary GSSM.
Determine if you have a full backup of the interim primary GSSM database
that you can restore on the new primary GSSM as follows:
If yes, restore the interim primary GSSM database. See the
Primary GSSM Backup"
Downgrading the GSSM
GSSM in your GSS network.
If no, determine if you have a backup of the original primary GSSM database
as follows:
If yes, restore the original primary GSSM database. See the
–
Primary GSSM Backup"
and Downgrading the GSSM
load-balancing configuration settings (DNS rules and keepalives) and
modify the settings as described in the Cisco Global Server
Load-Balancing Configuration Guide (GUI-based or CLI-based
version). You can now use the replacement primary GSSM in your GSS
network.
If no, proceed to Step 13.
–
If you do not have a backup of either the interim or original primary GSSM
database, do the following:
Replacing GSS Devices in Your GSS Network
section in Chapter 7,
Database. You can now use the replacement primary
section in Chapter 7,
Database. Verify the existing global server
Cisco Global Site Selector Administration Guide
"Restoring a
, Backing Up, Restoring, and
"Restoring a
, Backing Up, Restoring,
2-33