Specifying Iso Image Location And Transport Method - Cisco 750 Getting Started Manual

2. Select the appliance's management interface (generally
3. Select the protocol you are using for your management network:
Options for assigning an IP address to the management interface appear.
4. Select a method to assign an IP address to the management interface:
— If you select
length, and default gateway for the management interface.
— If you select
default gateway for the management interface, then displays the IP address.
5. When prompted, confirm your settings.
If prompted, confirm the IP address assigned to the appliance's management interface.
What to Do Next

Continue with the next section,

Specifying ISO Image Location and Transport Method

After you configure the management IP address that the restore process will use to download files it needs, you
must identify which ISO image you will use to restore the appliance. This is the ISO image that you downloaded
from the Support Site (see
server, or SCP-enabled host.
The interactive menu prompts you to enter any necessary information to complete the download, as listed in the
following table.
Table 3 Information Needed to Download Restore Files
To use... You must provide...

HTTP


FTP



SCP



Note that before you enter your password, the appliance may ask you to add the SCP
server to its list of trusted hosts. You must accept to continue.
Note that the restore utility will also look for update files in the ISO image directory.
To specify the restore files' location and transport method:
1. From the restore utility main menu, select
2. On the page that appears, select either
Cisco Firepower Management Center Getting Started Guide
Static , a series of pages prompts you to manually enter the IP address, network mask or prefix
, the appliance automatically detects the IP address, network mask or prefix length, and
DHCP
Specifying ISO Image Location and Transport
Obtaining the Restore ISO and Update Files, page
IP address for the web server
full path to the ISO image directory (for example,
IP address for the FTP server
path to the ISO image directory, relative to the home directory of the user whose
credentials you want to use (for example,
authorized user name and password for the FTP server
IP address for the SCP server
authorized user name for the SCP server
full path to the ISO image directory
password for the user name you entered earlier
Restoring a Firepower Management Center to Factory Defaults
).
eth0
/downloads/ISOs/
mydownloads/ISOs/
2 Choose the transport protocol
, , or .
HTTP FTP SCP
or .
IPv4 IPv6
or :
Static DHCP
Method.
14), and stored on a web server, FTP
)
)
.
19