Appendix E Various Operations - Cisco C880 M5 Service Manual

APP0500000

Appendix E Various Operations

APP0501000
E.1 Operation terminal connection
This section describes the operation terminal for work, setting and confirming of the Base Unit.
This server has no "Service engineer" dedicated port.
Thus operation of iRMC S5 on existing server must be done with specified terminal by consulting the
system administrator.
Select the operation terminal for work according to the system administrator.
In this document, FST and PC of customer equipment are not distinguished, they are denoted as the
operation terminal.
APP0501010
E.1.1 When connect the FST directly to the Base Unit by LAN cable
(1) Set IP Address, Subnet Mask and Gateway Address for the maintenance terminal exclusive use to
the FST.
(2) Connect form the FST LAN port to the management LAN port of the Base Unit by LAN cable.
APP0501020
E.1.2 When connect the FST to network switch by LAN cable (DHCP
disabled)
(1) Permission to connect FST with the switch on network is obtained.
(2) Set IP Address, Subnet Mask and Gateway Address for the maintenance terminal exclusive use to
the FST.
(3) Connect form the FST LAN port to the network switch port by LAN cable.
APP0501030
E.1.3 When connect the FST to network switch by LAN cable (DHCP
enabled)
(1) Permission to connect FST with the switch on network is obtained.
(2) Set DHCP enable to the FST.
(3) Connect form the FST LAN port to the network switch port by LAN cable.
103