ADEMCO VISTAKEY User Manual page 8

User Commands (cont'd)
Entry
#75
The #75 command may be used to change the state (grant, bypass, or
protect) of any access point. For the #75 command to be accepted, the
following conditions must be exist.
If the partition is armed, Armed Restriction is in effect, and the user
issues an access command, the user must be authorized to disarm
the partition for the command to be accepted.
The user must have an assignment level of Master or Manager.
The user must be assigned to the access point's partition to protect
or bypass the access point.
The VISTA user number must be assigned to the partition to which
the keypad belongs.
The VISTA user number must be assigned to a card with an access
group assignment that includes the point to which access is being
requested.
The VISTA user number does not have to be assigned to the
partition to which the access point belongs to be granted access, but
if not they will be denied access while the partition is armed when
an armed restriction has been programmed.
Enter the #75 command as follows:
User Code + # + 75
The following message is displayed on the keypad:
00-31
– 8 –
Entry or Exit
Press 0 for entry or 1 for exit. The access point
0
is unlatched for the time period defined by your
system installer.
Enter two digits (from 01 through 15) that
Access Point
01
correspond to the access point number where a
change of state is desired.