Block Delete - ADEMCO VISTAKEY User Manual

Performing Access Control Card Functions (cont'd)

Block Delete

Block Delete?
1=Yes 0=No
Delete from Card
1-250 0=Quit
To Card
1-250 0=Quit
Are you sure?
1=Yes 0=No
– 36 –
Press 1 or 0.
0
If you press 1, the system advances to the next
prompt.
If you press 0, the system advances to the
"Manual Delete?" prompt.
Enter the 3-digit number corresponding to the
001
beginning (lowest) card number for the deletion.
If you enter 000, the system advances to the
"Quit Card Mode?" prompt.
Press [*] to accept the entry.
Enter the 3-digit number corresponding to the
000
ending (highest) card number for the deletion.
NOTE: If this number is not greater than the
number entered as the "delete from" number
above, no cards are deleted.
Press [*] to accept the entry.
Press 1 or 0.
0
If you press 1, the system marks the selected
cards as deleted in the card database and
returns to the "Delete from Card" prompt.
If you press 0, the system returns to the "Delete
from Card" prompt without marking any cards
in the database for deletion.
Press [*] to accept the entry.