ADEMCO VISTAKEY User Manual page 25

Performing Access Control Card Functions (cont'd)
VISTA Card ID Number
001 Access Point?
(01-15) 00
VISTA Card ID Number
001 ACTION?
None 00
Press [*] to accept the entry.
NOTES:
If you selected 00 "never invoke," the system
advances to the "Block Entry" prompt.
For the ACS Event to occur, the card must be
swiped at the access point defined in the
following prompt.
Enter 1 through 15 for the access point number
corresponding to the event defined above.
Press [*] to accept the entry.
Enter two digits defining the action desired. For
acceptable entries and their meanings see, Table
1: Action Codes.
NOTES:
For the Action to occur, the ACS Event
(defined above) must have been invoked by a
card swipe at the access point defined in the
above prompt.
Actions that arm or disarm a partition will
only be performed if the VISTA User number
(for the card) is assigned to the partition to be
armed or disarmed.
Action codes 60 (AP Exit Only), 66 (AP Group
Exit Only), or 72 (AP Partition Exit Only)
disable the entry reader at the access point.
The reader will remain disabled until a
command is received (via a keypad command
or event) to protect the access point.
Press [*] to accept the entry.
In response to the action entered, the system
displays a message asking for additional
– 25 –