Editing Cards - ADEMCO VISTAKEY User Manual

Performing Access Control Card Functions (cont'd)

Editing Cards

This mode allows you to edit cards by entering the card number. To
edit cards based on a card swipe or the 12-digit card code, refer to the
"Adding Cards" procedure.
Edit Card
1=Yes 0=No
Card #
1-250 0=Quit
Press 1 or 0.
If you press 1, the system advances to the next
prompt.
If you press 0, the system advances to the "Auto
Delete" prompt.
Enter a valid card number from 001 to 250 or
001
000 to quit. Note that if you enter an invalid
card number, "ERROR" is displayed. (An invalid
card number is any number that has not already
been added into the system.)
If you entered a number from 001 to 250, the
system advances to the next prompt.
If you entered 000, the system advances to the
"Quit Card Mode?" prompt.
Press [*] to accept the entry.
NOTE: The display content while editing cards
is based on the definitions previously made for
the card being edited, and will not necessarily
match the examples provided in this procedure.
If the card has not been previously defined, an
error message is displayed notifying you to enter
a different number.
– 27 –