ADEMCO VISTAKEY User Manual page 17

Performing Access Control Card Functions (cont'd)
Cards mapped to valid VISTA users in the system always have
access to an access point and always can disarm a partition assigned
to their access group in Access Group Programming. See the two
examples below:
1. A card's access group was given access to a point by your system
installer and Armed Restriction was not set. The following table
illustrates the card's capabilities.
Executive
Card
Privilege
001 Yes
002 Yes
003 No
004 No
* "Any valid" means that the card is tied to a VISTA user who
also has access to the partition to which the access point is
assigned.
2. A card was given access to a point by your system installer and
Armed Restriction was set. The following table illustrates the
card's capabilities.
Executive
Card
Privilege
001 Yes
002 Yes
003 No
004 No
* "Any valid" means that the card is tied to a VISTA user who
also has access to the partition.
To begin #79 Card Function Programming, enter User Code + # + 79.
The following prompt is displayed on the keypad:
VISTA User Access Through Access
Number Point if System Armed
000 Yes
*Any Valid Yes
000 Yes
*Any Valid Yes
VISTA User Access Through Access
Number Point if System Armed
000 Yes
*Any Valid Yes
000 No
*Any Valid Yes
Disarm
System
Yes
Yes
Yes
Yes
Disarm
System
Yes
Yes
No
Yes
– 17 –