Auto Delete - ADEMCO VISTAKEY User Manual

Performing Access Control Card Functions (cont'd)
Quit?
1=YES 0=NO

Auto Delete

Auto Delete?
1=Yes 0=No
– 34 –
(for the card) is assigned to the partition to be
armed or disarmed.
Action codes 60 (AP Exit Only), 66 (AP Group
Exit Only), or 72 (AP Partition Exit Only)
disable the entry reader at the access point.
The reader will remain disabled until a
command is received (via a keypad command
or event) to protect the access point.
Press [*] to accept the entry.
In response to the action entered, the system
displays a message asking for additional
information where the display is dependent
upon the action selected. For example, if the
action selected is 01 (relay on), the system
presents a message asking for a relay number.
Respond to the message displayed, and then
press [*] to accept the entry.
Press 1 or 0.
0
If you press 1, the system advances to the "Quit
Card Mode?" prompt.
If you press 0, the system returns to the "Exec
Priv?" prompt.
Press 1 or 0.
0
If you press 1, the system advances to the next
prompt.
If you press 0, the system advances to the "Block
Delete?" prompt.