ADEMCO VISTAKEY User Manual page 7

#74
The #74 command may be used to grant entry or exit through any
access point. The access point will automatically relatch after a time
interval set by your system installer. For the #74 command to be
accepted, the following conditions must exist:
If the partition is armed and Armed Restriction is in effect, the user
must be authorized to disarm the partition.
The VISTA user number must be assigned to the partition to which
the keypad belongs.
The VISTA user number must be assigned to a card with an access
group assignment which includes the point to which access is being
requested.
The VISTA user number does not have to be assigned to the
partition to which the access point belongs to be granted access, but
if not they will be denied access while the partition is armed when
an armed restriction has been programmed.
Enter the #74 command as follows:
User Code + # + 74
The following message is displayed on the keypad:
Access Point
00-31 01
User Commands (cont'd)
Enter two digits (from 01 through 15) that
correspond to the access point number where
entry or exit is to be allowed.
NOTE: Entries between 16 and 31 are invalid
and will not cause any action.
Press the [*] key to accept the entry. The
following message is displayed on the keypad:
– 7 –