Time-Driven Events - ADEMCO VISTAKEY User Manual

Performing Scheduling Operations (cont'd)
Example: Enter 08:00 AM as the start time for time window 1.
Time Window
2. Enter the Stop Time desired for the time window. Note that
if your system uses a 24-hour clock (i.e., 5:00 PM displays as
17:00) the time entered here must also be based on a 24-hour
clock, so add 12 to any entries that are PM.
Example: Enter 05:00 PM as the stop time for time window 1.
Time Window
3. Repeat steps 1 and 2 for each time window desired.
When the worksheet entries have been completed, the time windows
may be programmed into the system as described in the Scheduling
Menu Mode paragraph later in this section. The Time-Driven Events
Worksheet (if desired) may be completed before programming the time
windows into the system.

Time-Driven Events

Time-Driven Events are used to make something occur (action) based
on time. Note that Time-Driven Events are optional and are not
required to operate the system. They are only used to have time cause
an action.
These are the schedules used to activate outputs, bypass zones, etc.
based on a time schedule. There are 20 events that may be
programmed for the system, with each event governed by a previously
defined time window.
– 40 –
Number
1
2
Number
1
2
Start Time
(HH:MM)
08:00 AM
Start Time
(HH:MM)
08:00 AM
Stop Time
(HH:MM)
Stop Time
(HH:MM)
05:00 PM