Output Device Control (#77) - ADEMCO VISTAKEY User Manual

User Commands (cont'd)
#79
The #79 command is used to add, remove, or edit cards in the system's
cardholder database. For instructions on using this command, refer to
Performing Access Control Card Functions.

Output Device Control (#77)

The #77 Output Device Control may used to activate outputs, bypass
zones, etc. under user control. The actions that may be activated by
the user are relay commands, arm/disarm commands, zone bypassing
commands, open/close access conditions, and access control commands.
For the #77 command to be accepted, the following conditions must
exist:
The user must have a level assignment of Master.
If the partition is armed, Armed Restriction is in effect, and the user
issues an access command, the user must be authorized to disarm
the partition for the command to be accepted.
The user must be assigned to the access point's partition to protect,
bypass, or lock the access point or to set it to exit only.
To arm or disarm a partition, the user must be assigned to that
partition.
The VISTA user number must be assigned to the partition to which
the keypad belongs.
The VISTA user number must be assigned to a card with an access
group assignment that includes the point to which access is being
requested.
The VISTA user number does not have to be assigned to the
partition to which the access point belongs to be granted access, but
if not they will be denied access while the partition is armed when
an armed restriction has been programmed.
– 10 –