Adding Cards - ADEMCO VISTAKEY User Manual

Performing Access Control Card Functions (cont'd)
Access Point
The system shows the "Add Card?" prompt. To add a card or edit a
card by using a card swipe, go to the "Adding Cards" paragraph below.
If you do not want to Add a card or edit a card by using a card swipe,
press 0 on the keypad to advance the display to another choice. When
the choice desired is displayed, stop pressing 0 and refer to the
corresponding paragraph in this section for procedural instruction.
The order in which the choices are displayed is as follows:
Add Card?
Edit Card?
AUTO Delete?
BLOCK Delete?
MANUAL Delete?
Quit Card Mode?

Adding Cards

Add Card?
1=Yes 0=No
– 18 –
Enter the number (01-15) of the access point
00
(door) for which you want to change card data.
Press [*] to accept the entry.
Press 1 to Enroll a card or Edit a card by using
0
a card swipe. Press 0 to advance to the Edit
Card Function. When you press 1, the following
prompt is displayed.
NOTE: When using this procedure to Edit a
card, the display content is based on the
definitions previously made for the card being
edited, and will not necessarily match the
examples provided here for this procedure.