Displaying The System Name; Setting The Switch's Ip Address - HP 1800 24G - ProCurve Switch Management And Configuration Manual

Using the ProCurve Web Browser Interface
Web Configuration

Displaying the System Name

You can identify the system by displaying the device name, location, and
contact information.
Field Attributes
Web – Click System, Name.

Setting the Switch's IP Address

This section describes how to configure an IP interface for management
access over the network. The IP address for this switch is 192.168.2.10 by
default. To manually configure an address, make sure the DHCP Enabled box
is unchecked, then change the switch's default settings (IP address
192.168.2.10 and netmask 255.255.255.0) to values that are compatible with
your network. You may also need to establish a default gateway between the
switch and management stations that exist on another network segment.
Field Attributes
2-8
• System Name – A name assigned to the switch system.
• System Location – Description of the switch location.
• System Contact – The contact name for the switch.
• DHCP Enabled – Enable or disable DHCP. If enabled, the IP address
will be acquired from a DHCP server. If disabled, the IP address must
be manually set by the user. (Default: Disabled)
• Switch IP Address – Address of the IP interface that is allowed
management access. Valid IP addresses consist of four numbers, 0 to
255, separated by periods. (Default: 192.168.2.10)