Intel E5405 - Cpu Xeon Quad Core 2.00Ghz Fsb1333Mhz 12M Lga771 Tray Specification page 20

buffer. The information in the PEBS record represents the state of the next instruction
to be executed following the counter overflow. Due to this erratum, if the counter
overflow occurs after execution of either MOV SS or STI, storage of the PEBS record is
delayed by one instruction.
Implication: When this erratum occurs, software may observe storage of the PEBS record being
delayed by one instruction following execution of MOV SS or STI. The state information
in the PEBS record will also reflect the one instruction delay.
Workaround: None identified.
Status: For the steppings affected, see the
AX8. Performance Monitoring Event FP_MMX_TRANS_TO_MMX May Not
Count Some Transitions
Problem: Performance Monitor Event FP_MMX_TRANS_TO_MMX (Event CCH, Umask 01H) counts
transitions from x87 Floating Point (FP) to MMX™ instructions. Due to this erratum, if
only a small number of MMX instructions (including EMMS) are executed immediately
after the last FP instruction, a FP to MMX transition may not be counted.
Implication: The count value for Performance Monitoring Event FP_MMX_TRANS_TO_MMX may be
lower than expected. The degree of undercounting is dependent on the occurrences of
the erratum condition while the counter is active. Intel has not observed this erratum
with any commercially available software.
Workaround: None identified.
Status: For the steppings affected, see the
AX9. A REP STOS/MOVS to a MONITOR/MWAIT Address Range May Prevent
Triggering of the Monitoring Hardware
Problem: The MONITOR instruction is used to arm the address monitoring hardware for the
subsequent MWAIT instruction. The hardware is triggered on subsequent memory store
operations to the monitored address range. Due to this erratum, REP STOS/MOVS fast
string operations to the monitored address range may prevent the actual triggering
store to be propagated to the monitoring hardware.
Implication: A logical processor executing an MWAIT instruction may not immediately continue
program execution if a REP STOS/MOVS targets the monitored address range.
Workaround: Software can avoid this erratum by not using REP STOS/MOVS store operations within
the monitored address range.
Status: For the steppings affected, see the
AX10. Performance Monitoring Event MISALIGN_MEM_REF May Over Count
Problem: Performance monitoring event MISALIGN_MEM_REF (05H) is used to count the number
of memory accesses that cross an 8-byte boundary and are blocked until retirement.
Due to this erratum, the performance monitoring event MISALIGN_MEM_REF also
counts other memory accesses.
Implication: The performance monitoring event MISALIGN_MEM_REF may over count. The extent of
the over counting depends on the number of memory accesses retiring while the
counter is active.
Workaround: None identified.
Status: For the steppings affected, see the
Intel® Xeon® Processor 5400 Series
Specification Update
Summary Tables of Changes.
Summary Tables of Changes.
Summary Tables of Changes.
Summary Tables of Changes.
20