Emulating An Epson Single-Station Printer (Single-Station Only); Enabling Epson Emulation; Printing Buffer Data - Single-Station Printers - IBM 4610-TM6 - SureMark Printer TM6 Two-color Thermal Transfer User Manual

August 24, 2004
2. To stop printing the data, open and close the ribbon cover. When you are ready
3. To stop printing and restart at the current position, open and close the paper
Printing buffer data – single-station printers
To print the buffer data from the beginning:
1. Open the top cover. The LED will flash quickly.
2. Press and hold the paper feed button for 5 seconds.
3. The LED will show one short blink, accompanied by a beep, followed by a
4. Press and hold the paper feed button for 5 seconds.
5. The LED will change to a long blink. The beeper will sound continuously.
6. Close the cover to begin printing the electronic journal data.
Notes:
1. If the SureMark printer encounters an error (for example, the paper runs out or
2. To stop printing the data, open the top cover, turn the printer power switch ON,
3. To stop printing and restart at the current position, open and close the top cover.
4. Pressing and releasing the paper feed button a third time before closing the top

Emulating an Epson single-station printer (single-station only)

Emulation of an Epson single-station printer is supported on the single-station
SureMark printers. See Appendix F, "Emulation support for Epson single-station
printer," on page 191.

Enabling Epson emulation

To enable emulation of an Epson single-station printer on a single-station SureMark
printer, you must set switch 3 on the main logic card. See Figure 17 on page 44 for
the location of the switch.
to print the data, use the procedure above to restart printing from the beginning.
cover. Printing immediately restarts.
1-second pause.
the cover is opened) while printing the data, the data remains intact.
turn the printer power switch OFF, and close the top cover. When you are ready
to print the data, use the procedure above to restart printing from the beginning.
Printing immediately restarts.
cover will cause the printer to return to normal mode.
Chapter 3. SureMark installation, service, and utility software
43