Flip Check - IBM 4610-TM6 - SureMark Printer TM6 Two-color Thermal Transfer User Manual

Character
MICR data representation
0–9
E13-B - Special characters
CMC7 - Special characters
Error Conditions:

Flip check

RS-232 Syntax:
Purpose:
Remarks:
Error Conditions:
160
SureMark Printers User's Guide
Description
Numerical data
blank
Unreadable
Character
Dash
Transit
On Us
Amount
Special character 1
Special character 2
Special character 3
Special character 4
Special character 5
Document feed error (status byte 7). This bit is set if the inserted check is
too long. The maximum check length is 10 inches. The error is also set if
the check does not clear the document sensor when expected.
ESC 5 or X'1B35'
To flip the check after a MICR read. This will allow the face of the check to
be printed.
v Set print station to document landscape mode to print the face of the
check.
v This command takes 5 seconds to complete.
v This command increments the line count (status byte 6).
v If landscape is selected before a check flip is done, when the check flip
is completed, the printer starts printing in landscape mode without
measuring the document first.
Document feed error (status byte 7). This bit is set if the inserted check is
too long. The maximum check length is 10 inches. The error is also set if
the check does not clear the document sensor when expected.
ASCII Representation
0–9
?
-
T
A
$
a
b
c
d
e
August 24, 2004
hex value returned
30–9
20
3F
2D
54
41
24
61
62
63
64
65