Rs-232 Hex Dump; Offline Printer Test Pattern - Models Tf6 And Tm6 - IBM 4610-TM6 - SureMark Printer TM6 Two-color Thermal Transfer User Manual

Suremark printers
Hide thumbs Also See for 4610-TM6 - SureMark Printer TM6 Two-color Thermal Transfer:
Table of Contents

Advertisement

August 24, 2004
Figure 39. Offline Printer Test Pattern – Models TF6 and TM6
Test Pattern Notes:
1. The serial number that prints will be the actual serial number of your printer. (If
2. The microcode level will be the actual level of your printer's microcode.
3. The serial interface will be specified as RS232, RS485, or USB, depending on
4. The line speed information appears only when the RS-232 interface is used.
5. The RS-232 control mode information appears only when the RS-232 interface
6. The feature-enabled lines will appear only when a feature is installed.
7. This section contains the test pattern.
8. This section contains printer usage statistics that you can use for problem
9. The line across the bottom should be solid with no blank spaces.

RS-232 hex dump

An RS-232 hex dump is provided to help diagnose problems with Models TM6 and
TF6.
To enable hex dump mode for the Model TF6 or TM6 printer, press and hold the
paper feed button while the printer is powered on. To exit, power OFF or reset the
printer.
The Printers S/N is 12345678
Microcode EC level is 30
Serial Interface: RS232
Serial Interface
Serial Interface
: 19.2K Baud, XON / XOFF
|"#$%&'()*+,-./0123456789:;<->?ABCDEFGHIKJK
LMNOPQRSTUVWXYZ[\]^_ abcdefghijklmnopqrstuvw
xyz{|}~.CüéâäàåcêëèïîìÄÅÉæÆôöòûùÿÖÜø£ØSsáíóú
ÁÑGg¿ · · · · ¡ · ·
ÁÂÀ
H III · · · · · · · · · · · · · Ð
I
õ ÊËÈÍÎÏÌÓßOO õÕµþÞUUUyY±÷
Cuts:
12301
CR Characters Printed:
CR Motor Steps:
CR Cover Openings:
CR Cut Fails:
7
the logic card has been replaced, this number must be reset to the original
serial number.)
which interface is used to attach the printer to the system unit.
The value can be either 9.6K baud or 19.2K baud, depending on the RS-232
switch settings. (See "RS-232 communication mode selections — all models
except TI8" on page 29.)
is used. The value can be either DTR/DSR or XON/XOFF, depending on the
RS-232 switch settings. (See "RS-232 communication mode selections — all
models except TI8" on page 29.)
determination.
·
I
¢ · · · · · · · · ãÃ
^
`
` ^
77626
88974
40
Chapter 7. Testing and problem analysis (Models TF6 and TM6)
1
2
3
4 5
6
7
·
`
` `
·
8
9
,
77

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ti1Ti2Ti3Ti4Ti8Tg3 ... Show all

Table of Contents