Fix Font Matrix; Print Logo Inline - IBM 4610-TM6 - SureMark Printer TM6 Two-color Thermal Transfer User Manual

August 24, 2004
|
|
|
|

Fix font matrix

|
|
|

Print logo inline

Default:
n = 00
Purpose:
To select the size of a character.
Remarks:
v This command is valid only in the thermal print station.
v Bits 3 and 8 of n are ignored.
v The Set Print Mode command (see "Set print mode" on page 127) can
also select the character height (double high and double wide). The last
command that is received is the effective command.
v Underline and overline is not supported when the height is scaled 8x
except on the TI8.
v The bar for overline and underline is not magnified in thickness except
on the TI8.
This command is supported only for Models TI3, TI4, TI8, TG3, TG4, TF6 and TM6.
RS-232 Syntax:
ESC : n or X'1B 3A n'
where:
n The character width to which all proportional characters will be
adjusted. The range of valid values is 8 ≤ n ≤ 32. Use X'00' to
disable this command and print proportional characters normally.
Default:
n = 00
Purpose:
To fix the matrix of proportional fonts. This command will be used mostly to
align numbers and decimal points.
Remarks:
v This command is valid only on proportional user-defined fonts.
v If the character is larger than the width defined by this command, then
the right side of the character will be truncated.
v If the character is smaller than the width defined by this command, then
the character will be centered in the space.
This command is supported for Model TM6 and the thermal station of Models TI3,
TI4, TI8, TG3, and TG4.
RS-232 Syntax:
GS J d n1 n2 data or X'1D 4A d n1 n2 data'
where:
d Relative height of the character.
0
1
n1 MSB of the logo width.
Single high
Double high
Appendix C. RS-232 programming information
143