Check Processing Commands (Models Ti2, Ti4, Ti8, And Tg4 Only); Model Ti8 Read Commands - IBM 4610-TM6 - SureMark Printer TM6 Two-color Thermal Transfer User Manual

Check processing commands (Models TI2, TI4, TI8, and TG4 only)

Model TI8 read commands

|
|
|
|
158
SureMark Printers User's Guide
Table 18. Retrievable usage data
Hex Value Usage Data Being Tracked
80 FRU Card/Invalid usage numbers (set to X'0164' at the
factory, not set for FRU logic cards)
81 Number of paper cuts
82 High byte of the number of characters printed on the CR
(thermal) station (see note 1)
83 Low byte of the number of characters printed on the CR
(thermal) station (see note 1)
84 Number of steps performed by the CR paper feed motor
(200 steps per inch of paper)
85 Number of times the customer receipt cover was opened
86 Number of failed paper cuts – single-station printers only
87 Number of characters printed at the DI (impact) station –
thermal/impact printers only (see note 1)
88 Number of steps performed by the DI paper feed motor –
thermal/impact printers only
89 Number of DI transport motor starts – thermal/impact printers
only
8A Number of home errors – thermal/impact printers only
8B Number of times the DI cover was opened – thermal/impact
printers only
8C Number of forms that were inserted into the DI station –
thermal/impact printers only
8D Number of MICR reads – Models TI4, TI8, and TG4 only
8E Number of high-interference MICR reads – Models TI4 and
TG4 only
8F Number of failed MICR reads – Models TI4, TI8, and TG4
only
90 Number of check flips performed – Models TI4, TI8, and TG4
only
91 Number of check flip failures – Models TI4, TI8, and TG4
only
Note 1: The number of printed characters is based on the number of dots that were printed,
assuming 64 dots per character.
This printer can process the check entirely without taking it from the printer. It can
read the magnetic ink character line, frank the back of the check, and flip the check
to print the face of the check.
Note: To print the face of the check, select the document station in landscape
mode as the print station.
The Model TI8 has two MICR read commands. For standard check processing
(those containing signatures or checks being processed as a standard paper
check), use the X'1B49' command, which is the same as that used in the Model TI4
August 24, 2004
Factor
N/A
32
None
None
50 000
None
None
1 000
50 000
5 000
None
None
100
15
8
8
16
8