Ga27-4151-03 - IBM 4610-TM6 - SureMark Printer TM6 Two-color Thermal Transfer User Manual

v Because there are important differences between models TF6 and TM6, which
v A new thermal font has been added. See "Set print mode" on page 127 and
v Support for emulation of an Epson single-station printer has been added. See
v A font conversion utility has been added as part of the support for proportional
v Information about uploading electronic journal data while the printer is emulating
v The following commands have been added:
v The following command, which is supported only on models TF6 and TM6, has

GA27-4151-03

This edition includes information for the support of a USB logic card.
Information that was added includes:
v "USB connector pin assignments" on page 87.
v USB information has been added to "Voltage conversion circuitry" on page 85.
v The part number for the available USB cables has been added to "Features used
xx
SureMark Printers User's Guide
are single-station SureMark printers, and the thermal/impact SureMark printers,
the book has been reorganized into three parts.
– Part 1 contains information that is similar for all SureMark models. Information
about the new single-station printers has been added throughout this part.
– Part 2 contains information that is specific to the thermal/impact SureMark
printers – models TI1, TI2, TI3, TI4, TG3, and TG4.
– Part 3 contains information that is specific to the new single-station SureMark
printers – models TF6 and TM6.
"Thermal printing font" on page 94.
"Emulating an Epson single-station printer (single-station only)" on page 43 for
information about how to enable emulation and an overview of the limitations to
using emulation mode. See Appendix F, "Emulation support for Epson
single-station printer," on page 191 for detailed information about what Epson
commands are supported in emulation mode.
fonts. See "Proportional font conversion utility" on page 38.
a Model 4 printer has been added. See Appendix D, "Uploading electronic journal
data," on page 185.
Note: These commands are not supported for models TI1 and TI2. Currently
installed Model TI3, TG3, TI4, and TG4 printers support these commands
after you download the latest firmware.
– "Proportional font" on page 117
– "Select color printing" on page 134
– n=09 (Align Column Right) for "Align positions" on page 137
– "Enable or disable upside-down printing" on page 142
– "Select character size for scalable fonts" on page 142
– "Fix font matrix" on page 143
– "Print logo inline" on page 143
– "Select thermal paper" on page 144
– n=09 (Code 128A, 128B, and 128C) for "Print bar code" on page 145
been added:
– "Enable or disable the beeper (Models TF6 and TM6 only)" on page 141
with the SureMark printers" on page 6.
August 24, 2004